Structural steel and sections
C+ and Z purlins
Plasterboard supports
Solar mounting systems
Rectangular tubes
19 sections from 30×20 to 150×100 · wall 1.5 to 6 mm
Nineteen sections, from 30 × 20 to 150 × 100. The rectangle carries load along its larger dimension: it is the profile for light purlins, trimmers and cladding framing.
- GradesS235JRH standard · S275J0H on request
- Standard length6,000 mm
- FinishesUncoated; shot-blasted and primed from 3 mm
- Cold-formed from hot-rolled strip
- Nineteen sections from 30×20 to 150×100 wall 1.5 to 6 mm
- Standard length 6 m other lengths on request
- Purlins, lintels and cross members
- Cladding and glazing frames
- Trailers, dump bodies and chassis
| Section | 1,5 mm | 2 mm | 2,5 mm | 3 mm | 3,5 mm | 4 mm | 5 mm | 6 mm | 8 mm | 10 mm | 12 mm |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 30 × 20 | · | · | · | — | — | — | — | — | — | — | |
| 35 × 20 | · | · | · | — | — | — | — | — | — | — | — |
| 40 × 20 | · | · | · | — | — | — | — | — | — | — | |
| 40 × 27 | · | · | · | — | — | — | — | — | — | — | |
| 40 × 30 | · | · | · | — | — | — | — | — | — | — | |
| 50 × 30 | · | · | · | — | — | — | — | — | |||
| 60 × 30 | · | · | · | — | — | — | — | — | |||
| 60 × 40 | · | · | · | — | — | — | |||||
| 70 × 40 | · | · | · | — | — | — | |||||
| 80 × 40 | · | · | · | — | — | — | |||||
| 80 × 60 | · | · | · | — | — | — | |||||
| 100 × 40 | · | · | · | — | — | — | |||||
| 100 × 50 | · | · | · | — | — | — | |||||
| 100 × 60 | · | · | · | — | — | — | |||||
| 100 × 80 | · | · | · | — | — | — | |||||
| 120 × 50 | · | · | · | — | — | — | |||||
| 120 × 80 | · | · | · | — | — | — | |||||
| 120 × 100 | · | · | · | — | — | — | |||||
| 150 × 100 | · | · | · | — | — | — |
Click a dot to add the section to your selection. Each section has its own thickness range: Ø21.3 stops at 2.5 mm, 150 × 100 starts at 3 mm.
Useful for this product
The table shows standard thicknesses. The forming line can make others: enter yours, from 1.5 to 12 mm.
Each section has its own thickness range: combinations missing from the table are not produced. Shot-blasting and primer only apply from 3 mm; below that, delivery is uncoated. Between a section's minimum and maximum, the thickness is free. Weight calculated from geometry at density 7.85: it ignores bend radii and overestimates by 1 to 2 percent. The sales offer uses the producer's table.